Data Acquisition Toolbox Major Bug Fixes

Advantech PCI-1711L now supported

The Advantech PCI-1711L board is now fully supported by the Data Acquisition Toolbox.

Measurement Computing boards would error with "MCC: Invalid BitNum specified"

Certain scenarios with the Measurement Computing digital I/O would result in the error "MCC: Invalid BitNum specified." This has been resolved in version 2.5.1.

Measurement Computing boards: hardware triggering fixed

A problem that might cause MATLAB to become unresponsive in certain scenarios when using hardware triggering on Measurement Computing boards has been resolved in version 2.5.1.

Measurement Computing PMD-1024HLS now supported

The Measurement Computing PMD-1024HLS is fully supported. Note that this device requires use of the Measurement Computing InstaCal driver version 5.52.

Measurement Computing PMD-1208FS now supported

Version 2.5.1 of the Data Acqusition Toolbox fully supports the Measurement Computing PMD-1208FS USB device. Note that this device requires Instacal version 5.53 from Measurement Computing.

Measurement Computing PMD-1608FS would error with "MCC: Count must be integer multiple of packetsize for recycle mode"

Certain scenarios with the Measurement Computing PMD-1608FS would result in the error "MCC: Count must be integer multiple of packetsize for recycle mode." This has been resolved in version 2.5.1.

National Instruments DSA cards now able to access all SampleRate values

Certain SampleRates were not avaliable to National Instruments DSA series cards. Essentially, all frequencies should be avaliable. This has been resolved for version 2.5.1.

Parallel Port accessible from MATLAB Compiler

The parallel port adaptor is fully accessible from the MATLAB compiler in version 2.5.1.