noisebw - Equivalent noise bandwidth of filter

Syntax

bw = noisebw(num, den, numsamp, Fs)

Description

bw = noisebw(num, den, numsamp, Fs) returns the two-sided equivalent noise bandwidth, in Hz, of a digital lowpass filter given in descending powers of z by numerator vector num and denominator vector den. The bandwidth is calculated over numsamp samples of the impulse response. Fs is the sampling rate of the signal that the filter would process; this is used as a scaling factor to convert a normalized unitless quantity into a bandwidth in Hz.

Examples

This example computes the equivalent noise bandwidth of a Butterworth filter over 100 samples of the impulse response.

Fs = 16; % Sampling rate
Fnyq = Fs/2; % Nyquist frequency
Fc = 0.5; % Carrier frequency
[num,den] = butter(2,Fc/Fnyq); % Butterworth filter
bw = noisebw(num,den,100,Fs)

The output is below.

bw =

    1.1049

Algorithm

The two-sided equivalent noise bandwidth is

where h is the impulse response of the filter described by num and den, and N is numsamp.

References

[1] Jeruchim, Michel C., Philip Balaban, and K. Sam Shanmugan, Simulation of Communication Systems, New York, Plenum Press, 1992.

muxintrlv

normlms

Free Early Verification Kit

Learn how to apply early verification to your development process through these technical resources.

Get technical kit

Trial software available

How much time do you spend on testing to ensure implementation meets system-level requirements?

Learn more