EDA Simulator Link™ IN

Workflow for Using the EDA Simulator Link™ IN Software with MATLAB^® Software

The following diagram illustrates the steps necessary to create and run a MATLAB^® test bench or component session.

This diagram assumes you have used the configuration and diagnostic script (either UNIX/Linux or Windows) and are starting Cadence Incisive or NC simulator outside of MATLAB software.

Note   This workflow is a recommendation only. You might create, compile, and elaborate your HDL module differently than illustrated before starting MATLAB software. The preceding illustration is simply one possible workflow.

Starting the HDL Simulator

Workflow for Using the EDA Simulator Link™ IN Software with Simulink® Software