Using Filterbuilder to Design a Filter :: Filter Design with Fdesign and Filterbuilder (Filter Design Toolbox™)

Using Filterbuilder to Design a Filter

Filterbuilder presents the option of designing a filter using a GUI dialog box as opposed to the command line instructions. You can use Filterbuilder to design the same bandpass filter designed in the previous section, Basic Filter Design Process

Example — Using Filterbuilder to Design a Simple Filter

To design the filter using FilterBuilder:

Type the following at the MATLAB prompt:
```
filterbuilder
```
The following dialog box opens:
Select Bandpass filter response from the list in the dialog box, and hit the OK button. The following dialog box opens:
Enter the correct frequencies for Fpass2 and Fstop2, as shown in the preceding figure, then click OK. Here the specification uses normalized frequency, so that the passband and stopband edges are expressed as a fraction of the Nyquist frequency (in this case, 48/2 kHz). The following message appears at the MATLAB prompt:
```
The variable 'Hbp' has been exported to the command window.
```
If you display the Workspace tab, as shown in the following figure, you see the object Hbp has been placed on your workspace.
To check your work, plot the filter magnitude response using the Filter Visualization tool. Verify that all the design parameters are met:
```
fvtool(Hbp) %plot the filter magnitude response
```

Basic Filter Design Process

Designing Multirate and Multistage Filters

Free Early Verification Kit

Learn how to apply early verification to your development process through these technical resources.

Get technical kit

Trial software available

How much time do you spend on testing to ensure implementation meets system-level requirements?

Learn more