Configuring SimMechanics Link Settings in Autodesk Inventor
About the SimMechanics Link Settings Dialog Box
You can access certain export settings from the SimMechanics
Link menu in your Autodesk Inventor menu bar.
To open the settings dialog box, select Settings.
Back to Top
Reviewing, Changing, and Applying Export Settings
The SimMechanics Link Export Settings dialog
box contains three active fields where you can specify linear and
angular tolerances as well as relative roundoff.
When the Inventor add-in creates joints from Inventor constraints,
it checks for vector alignments and spacing. Instead of comparing
these alignments and spacings with zero, it compares them with the Linear
tolerance and Angular tolerance that
you specify in this dialog box. The linear units are determined
by the assembly. The angular units are radians (rad). The Relative
tolerance specifies the smallest significant relative numerical
difference.
Click OK to save the settings
and close the SimMechanics Link Export Settings dialog
box.
If you do not want to save your settings, click Cancel to
close the SimMechanics Link Export Settings dialog
box.
Back to Top
 | Supported Autodesk Inventor Constraints and Their
Corresponding Joints | | Exporting Assemblies to Physical Modeling XML Format |  |
Learn more about Simulink through this collection of videos, articles, technical literature and the Getting Started with Simulink Guide.
Get this Simulink Kit
Store 
