Embedded Target for OSEK/VDX

Setting Up and Verifying Your Installation

The next sections describe how to configure your development environment for use with the Embedded Target for OSEK/VDX and verify correct operation. The initial configuration steps are described in the following sections:

• Setting Up Your Target Hardware
• Setting Target Preferences. The target preferences properties include information about your local system, such as the location of the OSEK implementation and debugger. Be sure to localize these properties appropriately for your installation.)

After completing these steps, proceed to the section appropriate to your development environment:

• If you are using OSEKWorks, see Setting Up Your Installation for the OSEKWorks Target.
• If you are using ProOSEK, see Setting Up Your Installation for the ProOSEK Target.

Hardware and Software Requirements

Setting Up Your Target Hardware