Requirements Management Interface

Viewing the Requirements for a Node

Use the Navigator to see which nodes have requirements associated with them. This is done when you are reviewing the objects (Simulink model, Stateflow diagram, or MATLAB M-file) requirements.

Select a node that has requirements associated with it. The requirements for that node appear in the right pane of the Navigator.

The shading of a node's icon in the Navigator indicates whether or not it has associated requirements, as shown in the following table.

Table 2-1: Node icons in the Navigator and What They Represent  

	Not shaded	Simulink subsystem with no requirements
	Shaded	Simulink subsystem that has requirements
	Lightly shaded	Simulink subsystem belonging to a subsystem that has requirements; subsystem itself has no requirements
	Not shaded	Simulink block with no requirements
	Shaded	Simulink block that has requirements
	Lightly shaded	Simulink block belonging to a subsystem that has requirements; block itself has no requirements
	Not shaded	Stateflow chart with no requirements
	Shaded	Stateflow chart that has requirements
	Lightly shaded	Stateflow chart belonging to a subsystem that has requirements; chart itself has no requirements
	Not shaded	Stateflow state with no requirements
	Shaded (with yellow)	Stateflow state that has requirements
	Lightly shaded	Stateflow state belonging to a superstate, chart, or subsystem that has requirements; state itself has no requirements
	Not shaded	Stateflow transition with no requirements
	Shaded (with blue)	Stateflow transition that has requirements
	Lightly shaded	Stateflow transition belonging to a superstate, chart, or subsystem that has requirements; transition itself has no requirements
	Not shaded	MATLAB M-file with no requirements
	Shaded	MATLAB M-file that has requirements

The following example shows that nodes for the N block in the valve timing subsystem and the positive edge to dual edge conversion subsystem are shaded, indicating they have requirements associated with them. The nodes under the positive edge to dual edge conversion subsystem are lightly shaded, indicating they belong to a subsystem that has requirements associated with it.

Stateflow Chart with Requirements

Note    Stateflow allows for multiple transitions at the same level to have the same name. However, the Requirements Management Interface does not support associating requirements documents with transition peers that have the same name.

This example shows the control logic Stateflow chart (in the fuel rate controller subsystem of the fuelsys model) with requirements.

MATLAB M-File with Requirements

This example shows the M-file engine.m with requirements

.

Viewing Requirements in the Navigator

Changing or Deleting a Requirement