MathWorks Automotive Conference 2013


9 May

Time Sessions
7:45 a.m. Registration, Breakfast, and Exhibits
8:30 a.m. Welcome
8:40 a.m. Keynote Presentation: Framework for Developing Complex Systems
Mehran Mestchian, MathWorks
9:05 a.m. Model-Based Control Design and Calibration Toolset for Downsized Boosted Engines
Yue-Yun Wang, General Motors Company
9:30 a.m. Practical Approaches for Re-architecture for AUTOSAR or Non-AUTOSAR Implementations
Dave Hoadley, MathWorks
9:50 a.m. Occupant Classification System Development: A Model-Based Design Odyssey
Russell Watts, Robert Bosch LLC
10:15 a.m. Break and Exhibits
10:45 a.m. JMAAB’s Activities for Advancing Best Practices for Model Verification
Yasumitsu Ito, MathWorks
Master Class:
Advanced Data Analysis with MATLAB
Sumit Tandon, MathWorks
11:10 a.m. Model-Based Design Environment for Lean Development
Lev Vitkin, Delphi Corporation
11:35 a.m. Optimizing Model-Based Design for ISO 26262: Framework and Case Study
Eric Dillaber, MathWorks
11:55 a.m. Lunch
1:00 p.m. Dynamic Vehicle Powertrain Model Development and Fuel System Hardware-in-the-Loop Simulator
Alan Brown and Doris Kotori, HELLA Electronics Corp.
Master Class:
AC Motor Control Architecture, Code Generation, and Verification
Greg Wolff, MathWorks
1:25 p.m. The Analysis of Vehicle Telediagnostic Data
Dennis Craggs, Chrysler Group LLC
1:50 p.m. Modeling Lithium-Based Batteries with Simscape
Javier Gazzarri, MathWorks
2:10 p.m. Dismantling the Land Speed Record: Data Analysis, Modeling, and Simulation for the Venturi Buckeye Bullet
R.J. Kromer, The Ohio State University Center for Automotive Research
2:35 p.m. Break and Exhibits
3:05 p.m. Designing Complex Driver Assistance Logic with MATLAB and Simulink
Reza Sahba, Magna Electronics
Master Class:
Modeling Multidomain Physical Systems Using Simscape
Vinay Gunasekaran, MathWorks
3:30 p.m. Developing and Verifying Active Safety Features Using MATLAB and Simulink
Chris Fillyaw, MathWorks
3:50 p.m. System Integration for Alternating Drives Between Machines and Human for Better Vehicle Fuel Efficiency
Zhijun Tang and Xubin Song, Eaton Corporation
4:15 p.m. Development of Engine Setpoint Controller Using Model-Based Design and xPC Target
Sam Lee, General Motors Company
4:40 p.m. Conference Conclusion