Plot linearization of a Simulink model at particular conditions during simulation. The Simulink Control Design software provides blocks that you can add to Simulink models to compute and
Use Simulink Control Design from command line. The MATLAB functions available in Simulink Control Design software allow for the programmatic specification of the input and output points
Specify the rate conversion method for the linearization of a multirate model. The choice of rate conversion methodology can affect the resulting linearized model. This example
The process that the command linearize uses when extracting a linear model of a nonlinear multirate Simulink model. To illustrate the concepts, the process is first performed using
Specify the linearization of a Simulink block or subsystem.
Use the slLinearizer interface to batch linearize a Simulink model. You vary model parameter values and obtain multiple open- and closed-loop transfer functions from the model.
Use System Identification Toolbox to identify a linear system for a model component that does not linearize well and use the identified system to specify its linearization. Note that
Use the command LINEARIZE to speed up the batch linearization where a set of block parameters are varied.
Approximate the nonlinear behavior of a system as an array of interconnected LTI models.
The features available in Simulink Control Design for linearizing models containing references to other models with a Model block.
Generate operating points using triggered snapshots.