LC Transmission Line and Test Bridge
This model shows a transmission line model and bi-directional test bridge. Reflected and transmitted signals are slightly different if the test direction is changed. This is because the line model is not symmetric. This type of model can be used both to explore the impact of cable choice on transmission characteristics, and also to compare relative fidelity of different transmission line model structures and parameterizations.
This model can be used to obtain the frequency response of the system. MATLAB command linmod can be used to linearize the model. If you have Simulink® Control Design™ installed, then you can do this by selecting Analysis->Control Design-> Linear Analysis to open the Linear Analysis Tool.
Bridge A Subsystem
5 Segments (S2 Subsystem)
Simulation Results from Simscape Logging
The plots below show the source, transmitted, and reflected signals for transmission tests from A to B and from B to A. Because the transmission line is asymmetric, differences can be seen in the reflected signals.