Raspberry Pi® LED Control
This example shows you how to control Raspberry Pi LED from an Android™ device.
Raspberry Pi is a popular, low-cost, credit card sized single-board computer. You can create compelling projects by using an Android device as a front end to control hardware and peripherals attached to a Raspberry Pi board wirelessly. In this example, you will configure and run two Simulink models onto Raspberry Pi hardware and Android device respectively. You will be able to control the LED on/off on Raspberry Pi board from Android device.
You will learn how to:
- Set up network connection between Raspberry Pi hardware and Android device
- Configure and run a Simulink model for Raspberry Pi hardware to receive UDP packets from Android device
- Configure and run a Simulink model for Android device to send UDP packets to Raspberry Pi hardware
- We recommend completing Getting Started with Android Devices example.
- Raspberry Pi board
- Android phone or tablet
Task 1 - Install Simulink Support Package for Raspberry Pi Hardware
You need Simulink Support Package for Raspberry Pi Hardware to run Simulink model on Raspberry Pi board.
2. (Recommended) Complete the Getting Started with Raspberry Pi® Hardware example in Simulink Support Package for Raspberry Pi Hardware you just installed.
Task 2 - Configure Network Connection
In this task, you will set up network connection between Raspberry Pi board and Android device. The communication protocol used in this example is UDP.
1. Connect Raspberry Pi board to the network with Ethernet cable through Ethernet port.
2. Connect Android device to the same network through Wi-Fi. Check Settings -> Wi-Fi -> [Wi-Fi network connected] to find the IP address of your Android device.
3. Verify the connection between your Raspberry Pi board and Android device.
Execute the following command on the MATLAB command prompt:
r = raspberrypi
This command returns an object with IP address info for the Raspberry Pi board.
Run command system(r, 'sudo ping [Android_IP_Address] -c 10') with the Android device IP address found in step 2 to verify the connection. e.g.
system(r, 'sudo ping 172.31.205.40 -c 10')
Task 3 - Run Simulink Models on Raspberry Pi Board and Android Device
1. Open preconfigured Raspberry Pi Model and configure it with the IP address of your Raspberry Pi board. Build and run this model on Raspberry Pi board by clicking on the Deploy to Hardware button.
2. Open preconfigured Android Model. Double-click on the UDP Send block. Open the block mask and enter the IP address of your Raspberry Pi board in the Remote IP address edit box. Click OK to save and close the block mask. Build and run this model on your Android device by clicking on the Deploy to Hardware button. An Android app will run on your Android device.
3. Once the Android app runs, press the switch button in the Android app and observe the LED on/off.
This example showed you how to create Simulink models that allow communication between a Raspberry Pi hardware board and Android device using UDP protocol.