Green Hills MULTI IDE Support from Embedded Coder

Generate code for MULTI IDE.

Altium Support from Embedded Coder

MATLAB Coder™, Simulink Coder™, and Embedded Coder® generate ANSI/ISO C/C++ code that can be compiled using the Green Hills® MULTI® IDE. Embedded Coder lets you easily configure the code generated from MATLAB® and Simulink® algorithms to control software interfaces, optimize execution performance, and minimize memory consumption. This capability is compatible with any version of MULTI.

Embedded Coder provides additional support for the Green Hills® MULTI® IDE including an automation interface capability from MATLAB, project generation from Simulink, and processor-in-the-loop (PIL) testing with Embedded Coder. The specific versions of MULTI required for this additional support are listed below.

You can also use Embedded Coder to create your own processor and board specific customizations using published APIs and reference examples. For example, you can generate processor-optimized (non- ANSI) code. MathWorks Consulting Services is available to assist with these customizations.

Ready to install?

MathWorks Requirements

Software

Required

Recommended

Support Package

Required

Target Installer automatically installs the support package for the MULTI IDE software. To install, type targetinstaller at the MATLAB command prompt. For manual downloads, see Embedded Coder Support Package for Green Hills MULTI IDE.

Third-Party Requirements

Software

Required

Green Hills MULTI IDE v 5.0.6 (Blackfin requires v 5.1.6). The following processor families are supported:

  • Analog Devices™ Blackfin®
  • ARM®
  • Freescale™ MPC5500, MPC7400, and MPC8641
  • NEC® V850

Request Hardware Support