Xilinx FPGA Board Support from HDL Verifier

Use HDL Verifier for FPGA-in-the-loop (FIL) support for FPGA-based verification on Xilinx FPGA boards.

Xilinx FPGA Board Support from HDL Verifier

HDL Verifier™ automates the verification of HDL code on Xilinx® FPGA boards by enabling FPGA-in-the-loop (FIL) testing. FIL testing helps ensure that the MATLAB® algorithm or Simulink® design behaves as expected in the real world, increasing confidence in your silicon implementation. The MATLAB algorithm or Simulink model is used to drive FPGA input stimuli and to analyze the output of the FPGA. With FIL testing, you can verify your design at FPGA speeds, enabling you to run more extensive sets of test cases and perform regression tests on your design.

HDL Verifier supports FIL verification over the Gigabit Ethernet interface for select Xilinx FPGA boards with Kintex-7, Spartan-6, Virtex-6, Virtex-5, and Virtex-4 devices.

Ready to install?

MathWorks Requirements

Software

Required

Recommended

Support Package

Required

Support Package Installer installs this support package. To start the installer, go to the MATLAB toolstrip and click Add-Ons > Get Hardware Support Packages. For more information, read the documentation.

Third-Party Requirements

Hardware

Required

One of the following Xilinx® boards:

  • Spartan®-6 SP605
  • Spartan-6 SP601
  • XUP Atlys Spartan-6
  • Virtex®-6 ML605
  • Virtex-5 ML505
  • Virtex-5 ML506
  • Virtex-5 ML507
  • Virtex-5 XUPV5–LX110T
  • Virtex-4 ML401
  • Virtex-4 ML402
  • Virtex-4 ML403
  • Kintex®-7 KC705

Software

Required

Request Hardware Support