Create systematic cyclic code from binary vector data
Block sublibrary of Error Detection and Correction
The Binary Cyclic Encoder block creates a systematic cyclic code with message length K and codeword length N. The number N must have the form 2M-1, where M is an integer greater than or equal to 3.
This block accepts a column vector input signal containing K elements. The out put signal is a column vector containing N elements.
You can determine the systematic cyclic coding scheme in one of two ways:
To create an [N,K] code, enter N and K as the first
and second dialog parameters, respectively. The block computes an
appropriate generator polynomial, namely,
To create a code with codeword length N and
a particular degree-(N-K) binary generator polynomial,
enter N as the first parameter and a polynomial
character vector or a binary vector as the second parameter.
The vector represents the generator polynomial by listing its coefficients
in order of ascending exponents. You can create cyclic generator polynomials
using the Communications System Toolbox™
For information about the data types each block port supports, see the Supported Data Type table on this page.
The codeword length, which is also the output vector length.
Either the message length, which is also the input vector length, a polynomial character vector, or a binary vector that represents the generator polynomial for the code.
|Port||Supported Data Types|
cyclpoly (in the Communications System Toolbox documentation)