Contents

General Block Interleaver

Reorder symbols in input vector

Library

Block sublibrary of Interleaving

Description

The General Block Interleaver block rearranges the elements of its input vector without repeating or omitting any elements. If the input contains N elements, then the Permutation vector parameter is a column vector of length N. The column vector indicates the indices, in order, of the input elements that form the length-N output vector; that is,

Output(k) = Input(Permutation vector(k))

for each integer k between 1 and N. The contents of Permutation vector must be integers between 1 and N, and must have no repetitions.

Both the input and the Permutation vector parameter must be column vector signals.

This block can output sequences that vary in length during simulation. For more information about sequences that vary in length, or variable-size signals, see Variable-Size Signal Basics in the Simulink® documentation.

This block accept the following data types: int8, uint8, int16, uint16, int32, uint32, boolean, single, double, and fixed-point. The output signal inherits its data type from the input signal.

Dialog Box

The General Block Interleaver dialog box is shown for the case in which the Permutation vector source parameter is set to Dialog.

The General Block Interleaver dialog box is shown for the case in which the Permutation vector source parameter is set to Input port.

Permutation vector source

A selection that specifies the source of the permutation vector. The source can be either Dialog or Input port. The default value is Dialog.

Permutation vector

A vector of length N that lists the indices of the output elements that came from the input vector. This parameter is available only when Permutation vector source is set to Dialog.

Examples

If Permutation vector is [4;1;3;2] and the input vector is [40;32;59;1], then the output vector is [1;40;59;32]. Notice that all of these vectors have the same length and that the vector Permutation vector is a permutation of the vector [1:4]'.

See Also

perms (MATLAB® function)

Was this topic helpful?