Create Hamming code from binary vector data
Block sublibrary of Error Detection and Correction
The Hamming Encoder block creates a Hamming code with message length K and codeword length N. The number N must have the form 2M-1, where M is an integer greater than or equal to 3. Then K equals N-M.
This block accepts a column vector input signal of length K. The output signal is a column vector of length N.
The coding scheme uses elements of the finite field GF(2M). You can either specify the primitive polynomial that the algorithm should use, or you can rely on the default setting:
To use the default primitive polynomial, simply enter N and K as
the first and second dialog parameters, respectively. The algorithm
gfprimdf(M) as the primitive polynomial for
To specify the primitive polynomial, enter N as
the first parameter and a binary vector as the second parameter. The
vector represents the primitive polynomial by listing its coefficients
in order of ascending exponents. You can create primitive polynomials
using the Communications System Toolbox™
In addition, you can specify the primitive polynomial
as a character vector,
'D^3 + D + 1'.
For information about the data types each block port supports, see the Supported Data Type table on this page.
The codeword length, which is also the output vector length.
The message length, which is also the input vector length or a binary vector that represents a primitive polynomial for GF(2M) or a polynomial character vector.
|Port||Supported Data Types|
hammgen (Communications System Toolbox)