Current value of Generalized Model
curval = getValue(M)
curval = getValue(M,blockvalues)
curval = getValue(M,Mref)
returns
the current value curval
= getValue(M
)curval
of the Generalized
LTI model or Generalized matrix M
.
The current value is obtained by replacing all Control
Design Blocks in M
by their current value.
(For uncertain blocks, the "current value" is the nominal
value of the block.)
uses
the block values specified in the structure curval
= getValue(M
,blockvalues
)blockvalues
to
compute the current value. The field names and values of blockvalues
specify
the block names and corresponding values. Blocks of M
not
specified in blockvalues
are replaced by their
current values.
inherits
block values from the generalized model curval
= getValue(M
,Mref
)Mref
.
This syntax is equivalent to curval
= getValue(M
,Mref.Blocks
).
Use this syntax to evaluate the current value of M
using
block values computed elsewhere (for example, tuned values obtained
with Robust Control Toolbox™ tuning commands such as systune
, looptune
,
or hinfstruct
).
 

Structure specifying blocks of The field names of 

Generalized
LTI model. If you provide 

Numeric array or Numeric LTI model representing
the current value of If you do not specify a replacement value for a given Control
Design Block of 
Evaluate Model for Specified Values of its Blocks
This example shows how to replace a Control Design Block in
a Generalized LTI model with a specified replacement value using getValue
.
Consider the following closedloop system:
The following code creates a genss
model
of this system with $$G\left(s\right)=\frac{\left(s1\right)}{{\left(s+1\right)}^{3}}$$ and
a tunable PI controller C.
G = zpk(1,[1,1,1],1); C = ltiblock.pid('C','pi'); Try = feedback(G*C,1)
The genss
model Try
has
one Control Design Block, C
. The block C
is
initialized to default values, and the model Try
has
a current value that depends on the current value of C
.
Use getValue
to evaluate C
and Try
to
examine the current values.
Evaluate C
to obtain its current
value.
Cnow = getValue(C)
This command returns a numeric pid
object
whose coefficients reflect the current values of the tunable parameters
in C
.
Evaluate Try
to obtain its current
value.
Tnow = getValue(Try)
This command returns a numeric model that is equivalent to feedback(G*Cnow,1)
.
Access Values of Tuned Models and Blocks
Propagate changes in block values from one model to another
using getValue
.
This technique is useful for accessing values of models and
blocks tuned with Robust Control Toolbox tuning commands such as systune
, looptune
,
or hinfstruct
. For example,
if you have a closedloop model of your control system T0
,
with two tunable blocks, C1
and C2
,
you can tune it using:
[T,fSoft] = systune(T0,SoftReqs);
You can then access the tuned values of C1
and C2
,
as well as any closedloop model H
that depends
on C1
and C2
, using the following:
C1t = getValue(C1,T); C2t = getValue(C2,T); Ht = getValue(H,T);
genss
 hinfstruct
 looptune
 replaceBlock
 systune