Specify time between consecutive scanned hardware channels
Note: You cannot use the legacy interface on 64–bit MATLAB®. See Session-Based Interface to acquire and generate data.
ChannelSkew applies only to scanning hardware and not to simultaneous sample and hold (SS/H) hardware.
If ChannelSkewMode is set to Minimum or Equisample, then ChannelSkew is automatically set to the appropriate device-specific read-only value. For SS/H hardware, the only valid ChannelSkew value is zero. For some vendors, ChannelSkewMode is automatically set to Manual if you first set ChannelSkew to a valid value.
AI, common to all channels
Read/write (depends on ChannelSkewMode value)
Read-only when running
For SS/H hardware, the only valid value is zero. For scanning hardware, the value depends on ChannelSkewMode. ChannelSkew is specified in seconds.