Documentation

This is machine translation

Translated by Microsoft
Mouseover text to see original. Click the button below to return to the English verison of the page.

Note: This page has been translated by MathWorks. Please click here
To view all translated materals including this page, select Japan from the country navigator on the bottom of this page.

Visualizing Multiple Signals Using Logic Analyzer

Visualize multiple signals of a programmable FIR filter by using a logic analyzer. For more information on the model used in this example and how to configure the model to generate HDL code, see Generate HDL Code for Programmable FIR Filter.

Model Programmable FIR Filter

Open the example model.

modelname = 'dspprogfirhdl';
open_system(modelname);

Consider two FIR filters, one with a lowpass response and the other with a highpass response. The coefficients can be specified using the InitFcn* callback function. To specify the callback, select File > Model Properties > Model Properties. In the dialog box, in the Callbacks tab, select InitFcn*.

The Programmable FIR via Registers block loads the lowpass coefficients from the Host Behavioral Model block and processes the input chirp samples first. The block then loads the highpass coefficients and processes the same chirp samples again.

Open the Programmable FIR via Registers block.

systemname = [modelname '/Programmable FIR via Registers'];
open_system(systemname);

Simulation

Run the example model.

sim(modelname)

Open the scope.

open_system([modelname '/Scope']);

Compare the DUT (Design under Test) output with the reference output.

Use the Logic Analyzer

The Logic Analyzer enables you to view multiple signals in one window. It also makes it easy to detect signal transitions.

The signals of interest (input coefficient, write address, write enable, write done, filter in, filter out, reference out, and error) have been marked for streaming in the model. Click the streaming button in the toolbar and select Logic Analyzer.

The Logic Analyzer displays waveforms of the selected signals.

Modify the Display

In the Logic Analyzer, you can modify the height of all the displayed channels, and the spacing between the channels. Click the Settings button. Then, modify the default height and spacing for each wave. Click Apply to show the new dimensions in the background.

To zoom in on the waveform, click the Zoom In Time button in the ZOOM & PAN section of the toolbar. Your cursor becomes a magnifying glass. Then click and drag to select an area on the waveform.

The Logic Analyzer now displays the time span you selected.

You can also control the display on a per-waveform basis. To modify an individual waveform, double-click the signal, select the signal, then click the WAVE tab to modify its settings.

Display the CoeffIn signal in signed decimal mode. The conversion uses the fractional and integer bits as defined for this signal in your model.

Another useful mode of visualization in the Logic Analyzer is the analog format. View the Filter In, Filter Out, and Ref Out signals in analog format.

You can also add dividers to the display. Click the Add Divider button in the toolbar.

Then specify a name for your divider on the DIVIDER tab. Add a second divider. A divider is added underneath the selected wave. If no wave is selected, it is added at the bottom of the display. To move the divider, click on the divider name and drag it to a new position. Alternatively, use the Move arrows on the DIVIDER tab.

Note the divider in its new position.

For more instructions on using the waveform display tool, see Logic Analyzer.

Was this topic helpful?