Set or modify model properties


sysnew = set(___)


set is used to set or modify the properties of a dynamic system model. Like its Handle Graphics® counterpart, set uses property name/property value pairs to update property values.

set(sys,'Property',Value) assigns the value Value to the property of the model sys specified by the string 'Property'. This string can be the full property name (for example, 'UserData') or any unambiguous case-insensitive abbreviation (for example, 'user'). The specified property must be compatible with the model type. For example, if sys is a transfer function, Variable is a valid property but StateName is not. For a complete list of available system properties for any linear model type, see the reference page for that model type. This syntax is equivalent to sys.Property = Value.

set(sys,'Property1',Value1,'Property2',Value2,...) sets multiple property values with a single statement. Each property name/property value pair updates one particular property.

sysnew = set(___) returns the modified dynamic system model, and can be used with any of the previous syntaxes.

set(sys,'Property') displays help for the property specified by 'Property'.


Consider the SISO state-space model created by

sys = ss(1,2,3,4);

You can add an input delay of 0.1 second, label the input as torque, reset the D matrix to zero, and store its DC gain in the 'Userdata' property by


Note that set does not require any output argument. Check the result with get by typing

               a: 1           
               b: 2           
               c: 3           
               d: 0           
               e: []          
       StateName: {''}        
   InternalDelay: [0x1 double]
              Ts: 0           
      InputDelay: 0.1         
     OutputDelay: 0           
       InputName: {'torque'}  
      OutputName: {''}        
      InputGroup: [1x1 struct]
     OutputGroup: [1x1 struct]
            Name: ''          
           Notes: {}          
        UserData: -2 

More About

expand all


For discrete-time transfer functions, the convention used to represent the numerator and denominator depends on the choice of variable (see tf for details). Like tf, the syntax for set changes to remain consistent with the choice of variable. For example, if the Variable property is set to 'z' (the default),

set(h,'num',[1 2],'den',[1 3 4])

produces the transfer function


However, if you change the Variable to 'z^-1' by


the same command

set(h,'num',[1 2],'den',[1 3 4])

now interprets the row vectors [1 2] and [1 3 4] as the polynomials 1 + 2z−1 and 1 + 3z−1 + 4z−2 and produces:


    Note   Because the resulting transfer functions are different, make sure to use the convention consistent with your choice of variable.

See Also

| | | | | | | | | | | | |

Was this topic helpful?