To use the Control Point Selection Tool, enter the
at the MATLAB® prompt. As arguments, specify the image you want
to register (the moving image) and the image you want to compare it
to (the fixed image).
For simplicity, this section uses the same image as the moving and the fixed image. To walk through an example of an actual registration, see Register an Aerial Photograph to a Digital Orthophoto.
moon_fixed = imread('moon.tif'); moon_moving = moon_fixed; cpselect(moon_moving, moon_fixed);
cpselect command has other optional arguments.
For example, you can restart a control point selection session by
cpstruct structure as the third argument.
For more information about restarting sessions, see Export Control Points to the Workspace.
For complete details, see the
When the Control Point Selection Tool starts, it contains three primary components:
Details windows—The two windows displayed at the top of the tool are called the Detail windows. These windows show a close-up view of a portion of the images you are working with. The moving image is on the left and the fixed image is on the right.
Overview windows—The two windows displayed at the bottom of the tool are called the Overview windows. These windows show the images in their entirety, at the largest scale that fits the window. The moving image is on the left and the fixed image is on the right. You can control whether the Overview window appears by using the View menu.
Details rectangle—Superimposed on the images displayed in the two Overview windows is a rectangle, called the Detail rectangle. This rectangle controls the part of the image that is visible in the Detail window. By default, at startup, the detail rectangle covers one quarter of the entire image and is positioned over the center of the image. You can move the Detail rectangle to change the portion of the image displayed in the Detail windows.
The following figure shows these components of the Control Point Selection Tool.