This is machine translation

Translated by Microsoft
Mouseover text to see original. Click the button below to return to the English verison of the page.

Note: This page has been translated by MathWorks. Please click here
To view all translated materals including this page, select Japan from the country navigator on the bottom of this page.

Communicating with EEPROM using SPI bus

This example shows how to communicate with EEPROM AT25080A on Aardvark's I2C/SPI Activity Board over the Serial Peripheral Interface (SPI) bus.

To begin, create an SPI object. For this example, we are using Aardvark's I2C/SPI Activity Board which has both board index and address as 0. To connect the computer to the SPI bus, a USB-I2C/SPI adaptor from Aardvark is used. For SPI object creation, this translates to:

  • Vendor = aardvark

  • BoardIndex = 0

  • Port = 0

eeprom = spi('aardvark',0,0);
SPI Object : 

	Adapter Settings
		BoardIndex:            0
		BoardSerial:           2237727782
		VendorName:            aardvark

	Communication Settings
		BitRate:               1000000 Hz
		ChipSelect:            0
		ClockPhase:            FirstEdge
		ClockPolarity:         IdleLow
		Port:                  0

	Communication State
		ConnectionStatus:      Disconnected

	Read/Write State
		TransferStatus:        Idle

Before you can perform a read or write operation, you must connect the SPI object to the device using the connect function. You can verify that the object has been successfully connected, by checking its ConnectionStatus property. Once connected to the device, the property ConnectionStatus is automatically updated to be Connected.

ans =


SPI operates in full duplex mode. Hence for any read/write operation, data is always transferred in both directions. This can be illustrated with a simple task of writing 'Hello' to EEPROM and reading it back.

The EEPROM's datasheet specifies the following for reading and writing data:

  • The chip should be write-enabled before writing anything to it.The chip can be write-enabled by writing 6 to it. NOTE: If the chip is not write-enabled, it will ignore the write instruction and will return to the standby state

  • Data should be written to the chip in the following format:

[Write_Command Upper_Byte_Address Lower_Byte_Address data1 data2 ...]

The Write_Command for this EEPROM is 2.

  • Data should be written to the chip in the following format to read it back correctly:

[Read_Command Upper_Byte_Address Lower_Byte_Address zeros(1,size of data to be read back)]

The Read_Command for this EEPROM is 3.

Write-enable the eeprom


Write 'Hello' at the 0th address of EEPROM using the write function.

dataToWrite = [2 0 0 double('Hello')];
write(eeprom, dataToWrite);

We can now read data back from EEPROM.

dataToWrite = [3 0 0 zeros(1,5)];
returnedData = writeAndRead(eeprom, dataToWrite);

The data returned is:

  • Bytes 1:3 - Don't care

  • Fourth byte onwards - Data read back from EEPROM

In this case, the data read back is:

ans =


Disconnect the SPI object and remove it from memory and the workspace.

Was this topic helpful?