|On this page…|
So far in this chapter, you have only run individual test steps after each was created.
When you run the entire test, all the test steps run in the order listed in the Test Explorer tree. Using the mouse, you may drag the nodes of the tree to alter their sequence.
The Output Window displays the results of each step, along with a final result of the complete test.
Earlier you entered a value of 80 to illustrate what a failure looks like. The display contrast is left at 100 from the Set Display Contrast test step, so that is what you will test for in the next step.
Using the context menu in the Test Explorer tree, you can run a partial test of either an individual test step, or from the chosen test step through the end of the test.
You can export the test results to many locations:
MATLAB figure window
MATLAB Variables editor
The results you can export are those assigned to output variables in the settings for a test step.
By default, all the variables are selected. You may unselect any.
The variables are now available in the MATLAB workspace, with values that were established by the test run.