Stop MATLAB worker session
stopworker stops a MATLAB® worker process that is running under the mdce service.
stopworker executable resides in the folder
(Windows® operating system) or
(UNIX® operating system). Enter the following command syntax at a DOS or UNIX command-line prompt, respectively.
stopworker accepts the following
input flags. Multiple flags can be used together on the same command.
|Specifies the name of the MATLAB worker to stop. The default is the value of the
|Specifies the name of the host where you want to stop the MATLAB worker. The default value is the local host.|
|Deletes all checkpoint information associated with this worker name after stopping it.|
|Specifies the base port that the mdce service on the remote host is using.
You need to specify this only if the value of |
|Verbose mode displays the progress of the command execution.|
Stop the worker with the default name on the local host.
Stop the worker with the default name, running on the computer
stopworker -remotehost WorkerHost
Stop the workers named
running on the computer
stopworker -name worker1 -remotehost WorkerHost stopworker -name worker2 -remotehost WorkerHost