Calculate dissipated power losses

`lossesTable = elec_getPowerLossSummary(node)`

`lossesTable = elec_getPowerLossSummary(node,startTime,endTime)`

calculates
dissipated power losses for semiconductor blocks in a model, based
on logged simulation data, and returns the data for each block in
a table. `lossesTable`

= elec_getPowerLossSummary(`node`

)

Before you call this function, you must have the simulation
log variable in your current workspace. Create the simulation log
variable by simulating the model with data logging turned on, or load
a previously saved variable from a file. If `node`

is
the name of the simulation log variable, then the table contains the
data for all semiconductor blocks in the model. If `node`

is
the name of a node in the simulation data tree, then the table contains
the data only for the blocks within that node.

Checking dissipated power is useful for verifying that circuit
components are operating within their working envelopes. All blocks
in the Semiconductor Devices library, as well as some other blocks,
have an internal variable called `power_dissipated`

,
which represents the instantaneous power dissipated by the block.
When you log simulation data, the time-value series for this variable
represents the power dissipated by the block over time. You can view
and plot this data using the Simscape™ Results Explorer.

The `elec_getPowerLossSummary`

function calculates
average losses for each block that has a `power_dissipated`

variable.
Some blocks have more than one `power_dissipated`

variable,
depending on their configuration. For example, the N-Channel
MOSFET block has separate `power_dissipated`

logging
nodes for the MOSFET, the gate resistor, and for the source and drain
resistors if they have nonzero resistance values. The function sums
all these losses and provides the power loss value for the whole block,
averaged over simulation time.

calculates
dissipated power losses within a time interval. `lossesTable`

= elec_getPowerLossSummary(`node`

,`startTime`

,`endTime`

)`startTime`

and `endTime`

represent
the start and end of the time interval for averaging the power losses.
If you omit these two input arguments, the function averages the power
losses over the whole simulation time.

`elec_getEfficiency`

| `elec_getPowerLossTimeSeries`

| `sscexplore`

- About Simulation Data Logging (Simscape)
- About the Simscape Results Explorer (Simscape)

Was this topic helpful?