Documentation |
Hydraulic orifice with constant cross-sectional area
The Fixed Orifice block models a sharp-edged constant-area orifice, flow rate through which is proportional to the pressure differential across the orifice. The flow rate is determined according to the following equations:
$$q={C}_{D}\cdot A\sqrt{\frac{2}{\rho}}\cdot \frac{p}{{\left({p}^{2}+{p}_{cr}^{2}\right)}^{1/4}}$$
$$p={p}_{A}-{p}_{B}$$
$${p}_{cr}=\frac{\rho}{2}{\left(\frac{{\mathrm{Re}}_{cr}\cdot \nu}{{C}_{D}\cdot {D}_{H}}\right)}^{2}$$
$${D}_{H}=\sqrt{\frac{4A}{\pi}}$$
where
q | Flow rate |
p | Pressure differential |
p_{A}, p_{B} | Gauge pressures at the block terminals |
C_{D} | Flow discharge coefficient |
A | Orifice passage area |
D_{H} | Orifice hydraulic diameter |
ρ | Fluid density |
ν | Fluid kinematic viscosity |
p_{cr} | Minimum pressure for turbulent flow |
Re_{cr} | Critical Reynolds number |
The block positive direction is from port A to port B. This means that the flow rate is positive if it flows from A to B, and the pressure differential is determined as $$p={p}_{A}-{p}_{B}$$.
Orifice passage area. The default value is 1e-4 m^2.
Semi-empirical parameter for orifice capacity characterization. Its value depends on the geometrical properties of the orifice, and usually is provided in textbooks or manufacturer data sheets. The default value is 0.7.
The maximum Reynolds number for laminar flow. The transition from laminar to turbulent regime is assumed to take place when the Reynolds number reaches this value. The value of the parameter depends on the orifice geometrical profile. You can find recommendations on the parameter value in hydraulics textbooks. The default value is 12, which corresponds to a round orifice in thin material with sharp edges.
Use the Variables tab to set the priority and initial target values for the block variables prior to simulation. For more information, see Set Priority and Initial Target for Block Variables.
Parameters determined by the type of working fluid:
Fluid density
Fluid kinematic viscosity
Use the Hydraulic Fluid block or the Custom Hydraulic Fluid block to specify the fluid properties.