Documentation Center |
Ideal compressor with signal-controlled mass flow rate
The Controlled Pneumatic Flow Rate Source block represents an ideal compressor that maintains a mass flow rate equal to the numerical value presented at physical signal port F. The compressor adds no heat. Block connections A and B correspond to the pneumatic inlet and outlet ports, respectively, and connection F represents a control signal port.
The block positive direction is from port A to port B. This means that the flow rate is positive if it flows from A to B. The pressure differential is determined as p = p_{A} – p_{B} and is negative if pressure at the source outlet is greater than pressure at its inlet. The power generated by the source is negative if the source adds energy to the flow.
Warning Be careful when driving an orifice directly from a flow rate source. The choked flow condition limits the flow that is possible through an orifice as a function of upstream pressure and temperature. Hence the flow rate value produced by the flow rate source must be compatible with upstream pressure and temperature. Specifying a flow rate that is too high will result in an unsolvable set of equations. |
Pneumatic Flow Rate Source | Pneumatic Mass & Heat Flow Sensor