Documentation |
Mutual inductor in electrical systems
The Mutual Inductor block models a mutual inductor, described with the following equations:
$$V1=L1\frac{dI1}{dt}+M\frac{dI2}{dt}$$
$$V2=L2\frac{dI2}{dt}+M\frac{dI1}{dt}$$
$$M=k\sqrt{L1\xb7L2}$$
where
V1 | Voltage across winding 1 |
V2 | Voltage across winding 2 |
I1 | Current flowing into the + terminal of winding 1 |
I2 | Current flowing into the + terminal of winding 2 |
L1, L2 | Winding self-inductances |
M | Mutual inductance |
k | Coefficient of coupling, 0 < k < 1 |
t | Time |
This block can be used to represent an AC transformer. If inductance and mutual inductance terms are not important in a model, or are unknown, you can use the Ideal Transformer block instead.
The two electrical networks connected to the primary and secondary windings must each have their own Electrical Reference block.
Self-inductance of the first winding. The default value is 10 H.
Self-inductance of the second winding. The default value is 0.1 H.
Coefficient of coupling, which defines the mutual inductance. The parameter value should be greater than zero and less than 1. The default value is 0.9.
Use the Variables tab to set the priority and initial target values for the block variables prior to simulation. For more information, see Set Priority and Initial Target for Block Variables.
The block has four electrical conserving ports. Polarity is indicated by the + and – signs. Ports labeled +1 and –1 are connected to the primary winding. Ports labeled +2 and –2 are connected to the secondary winding.