Mutual inductor in electrical systems
The Mutual Inductor block models a mutual inductor, described with the following equations:
|Voltage across winding 1|
|Voltage across winding 2|
|Current flowing into the + terminal of winding 1|
|Current flowing into the + terminal of winding 2|
|Coefficient of coupling, 0 < |
This block can be used to represent an AC transformer. If inductance and mutual inductance terms are not important in a model, or are unknown, you can use the Ideal Transformer block instead.
The two electrical networks connected to the primary and secondary windings must each have their own Electrical Reference block.
Use the Variables tab in the block dialog box (or the Variables section in the block Property Inspector) to set the priority and initial target values for the block variables prior to simulation. For more information, see Set Priority and Initial Target for Block Variables.
Self-inductance of the first winding. The default value is
Self-inductance of the second winding. The default value is
Coefficient of coupling, which defines the mutual inductance.
The parameter value should be greater than zero and less than 1. The
default value is
The block has four electrical conserving ports. Polarity is indicated by the + and – signs. Ports labeled +1 and –1 are connected to the primary winding. Ports labeled +2 and –2 are connected to the secondary winding.