|On this page…|
Model Report is a SimMechanics™ tool that provides model assembly status and parameters. Use Model Report to:
Identify joints and constraints with assembly issues.
Identify joints with unsatisfied state targets.
Compare specified and actual joint state targets.
Obtain relevant statistics for a model
Model Report is accessible from Mechanics Explorer. To open Model Report:
Update or simulate a SimMechanics model.
In the Mechanics Explorer menu bar, click Tools > Model Report.
Model Report opens with assembly status and parameters relevant to the current model.
Model Report contains one header section and three tabs:
Header — Provides model-wide assembly status.
Joints — Provides assembly status and state target values for each joint block in a model. The following figure shows the Joints tab for example sm_four_bar.
Constraints — Provides assembly status for each constraint block in a model. The following figure shows the Constraints tab for example sm_four_bar.
Statistics — Provides model-wide statistics. Parameters include number of joints, constraints, and kinematic degrees of freedom in a model. The following figure shows the Statistics tab for example sm_four_bar.
Model Report uses three icons to identify the assembly status of a model, joint block, or constraint block.
|Assembled without issues. In joint blocks, the icon indicates state target was successfully met.|
|Assembled with issues. In Joint blocks, the icon indicates the state target was approximately met.|
|Not assembled. In Joint blocks, the icon indicates the state target was not met.|