Implement insulated gate bipolar transistor (IGBT)
Fundamental Blocks/Power Electronics
The IGBT block implements a semiconductor device controllable by the gate signal. The IGBT is simulated as a series combination of a resistor Ron, inductor Lon, and a DC voltage source Vf in series with a switch controlled by a logical signal (g > 0 or g = 0).
The IGBT turns on when the collector-emitter voltage is positive and greater than Vf and a positive signal is applied at the gate input (g > 0). It turns off when the collector-emitter voltage is positive and a 0 signal is applied at the gate input (g = 0).
The IGBT device is in the off state when the collector-emitter voltage is negative. Note that many commercial IGBTs do not have the reverse blocking capability. Therefore, they are usually used with an antiparallel diode.
The IGBT block contains a series Rs-Cs snubber circuit, which is connected in parallel with the IGBT device (between terminals C and E).
The turnoff characteristic of the IGBT model is approximated by two segments. When the gate signal falls to 0, the collector current decreases from Imax to 0.1 Imax during the fall time (Tf), and then from 0.1 Imax to 0 during the tail time (Tt).
The internal resistance Ron, in ohms (Ω). Default is
The Resistance Ron parameter cannot
be set to
0 when the Inductance
Lon parameter is set to 0.
The internal inductance Lon, in henries (H). Default is
The Inductance Lon parameter is normally
0 except when the Resistance
Ron parameter is set to
The forward voltage of the IGBT device, in volts (V). Default
You can specify an initial current flowing in the IGBT. Default
0. It is usually set to
start the simulation with the device blocked.
If the Initial Current IC parameter
is set to a value greater than
0, the steady-state
calculation considers the initial status of the IGBT as closed. Initializing
all states of a power electronic converter is a complex task. Therefore,
this option is useful only with simple circuits.
The snubber resistance, in ohms (Ω). Default is
Set the Snubber resistance Rs parameter
inf to eliminate the snubber from the model.
The snubber capacitance in farads (F). Default is
Set the Snubber capacitance Cs parameter
0 to eliminate the snubber, or to
get a resistive snubber.
If selected, add a Simulink® output to the block returning the diode IGBT current and voltage. Default is selected.
Simulink signal to control the opening and closing of the IGBT.
The Simulink output of the block is a vector containing two signals. You can demultiplex these signals by using the Bus Selector block provided in the Simulink library.
The IGBT block implements a macro model of the real IGBT device. It does not take into account either the geometry of the device or the complex physical processes .
Depending on the value of the inductance Lon, the IGBT is modeled either as a current source (Lon > 0) or as a variable topology circuit (Lon = 0). The IGBT block cannot be connected in series with an inductor, a current source, or an open circuit, unless its snubber circuit is in use.
The inductance Lon is forced to 0 if you choose to discretize your circuit.
illustrates the use of the IGBT block in a boost DC-DC converter.
The IGBT is switched on and off at a frequency of 10 kHz to transfer
energy from the DC source to the load (RC). The average output voltage
(VR) is a function of the duty cycle (α)
of the IGBT switch:
 Mohan, N., T.M. Undeland, and W.P. Robbins, Power Electronics: Converters, Applications, and Design, John Wiley & Sons, Inc., New York, 1995.