Compute mean value of signal
Control and Measurements/Measurements
The Mean (Variable Frequency) block computes the mean value of the signal connected to the second input of the block. The mean value is computed over a running average window of one cycle of the frequency of the signal:
This block uses a running average window. Therefore, one cycle of simulation must complete before the block outputs the computed mean value. For the first cycle of simulation, the output is held constant to the specified initial value.
Specify the frequency of the first cycle of simulation. Default
The minimum frequency value determines the buffer size of the
Variable Time Delay block used inside the block to compute the mean
value. Default is
Specify the initial value of the input during the first cycle
of simulation. Default is
Specify the sample time of the block, in seconds. Set to
implement a continuous block. Default is
The frequency of the signal.
Connects to the signal to be analyzed.
The mean value of the signal.
|Sample Time||Specified in the Sample Time parameter|
Continuous if Sample Time = 0
|Scalar Expansion||Yes, of the parameters|
compares the Mean block to the Mean (Variable
Frequency) block for three identical input signals. It shows
that, even if the frequency of the input signals varies during the
simulation, the Mean (Variable Frequency) block outputs correct values.
The model sample time is parameterized by the Ts variable with a default value of 50e-6 s. Set Ts to 0 in the command window to simulate the model in continuous mode.