Produce spur graph for multiband transmitter or receiver
Vertical green bands, representing spur-free zones.
Horizontal colored bands, representing spurious regions.
The following figure shows a spur graph for the three-mixer
multiband receiver example on the
Spur-free zones are ranges of possible IF center frequencies
that are free from intermodulation distortion. Depending on the configuration
of the mixers in
hif, spur-free zones may not appear.
Clicking on a spur-free zone produces a tooltip, which displays information
about the spur-free zone:
Min IFCF — The minimum possible IF center frequency fIF for the corresponding spur-free zone.
Max IFCF — The maximum possible IF center frequency fIF for the corresponding spur-free zone.
Spurious regions contain intermodulation products from at least one mixer. The color of a spur on the spur graph indicates which mixer generates the spur, according to the legend on the spur graph. Clicking on a spurious region produces a tooltip, which displays information about the spur:
RF Center Freq — The RF center frequency fRF of the mixer that generates the spur
M, N — The coefficients in the equation |MfRF – N(fRF ± fIF)| (down-conversion) or the equation |MfIF + N(fRF ± fIF)|. The sign of ‘±’ in these equations is determined by the injection type of the mixer. These coefficients refer to the particular mixing product that generates the spurious region.
Spur Level — The difference
in magnitude between a signal at 0 dBc and the spur. If you set
a number greater than this value, then
not report the region as spurious.
Freq Range — The frequency range of the spurious region. Choosing an IF center frequency in this range causes interference with the intermodulation product corresponding to the spur.
hif— IF planning object
Intermediate frequency planning (IF) object, specified as an
returns the endpoints of the spur-free zones in a matrix.
report method displays mixer
configurations, intermodulation tables, and spur-free zone information
at the command line.