Insert a table that links data dictionary information to requirements
This component inserts a table into the report. The table links data dictionary information to corresponding requirements. This component reports on the currently open data dictionary. Place this component inside a section, paragraph, or table component.
To use this component, your report setup must include
that open a data dictionary or determine the data dictionary that
is open. To open a template report that shows an example of these
at the MATLAB® command prompt, enter:
Eval statements in the
at the beginning of the report setup.
Specify information about the table.
Table title: Specify the table title.
No title — Do not
include a table title.
Object name — Use
the name of the data dictionary in the title.
Custom — Specify
your own table title.
Specify the table columns that you want to include in the report. The Document name, Locations within document, and Requirement keyword check boxes correspond to properties on the Requirements Management Interface Link Editor dialog box.
Description — Include the description of the requirement. The description helps you to identify the requirement the table is linking to. Leave this box selected to improve the readability of your table.
Document name — Include the name of the document where the requirement is located.
Locations within document — Include the identifier of a location in the document.
Requirement keyword — Include the requirement keyword.