Documentation Center

  • Trial Software
  • Product Updates

Real-Time Filter

This is a model of real-time filter built using DSP System Toolbox™ and Real-Time Windows Target™. The unfiltered signal is acquired by the analog input, passed through a filter designed by DSP System Toolbox and finally sent to analog output. Both the unfiltered and filtered signals are shown in real-time using the Scope block.

How to run this model in Normal Mode:

  1. Open the Analog Input and Analog Output blocks and select your data acquisition board. If there's no board installed, install it using the Install new board button.

  2. Double-click the orange button to switch to Normal Mode if needed.

  3. Start the real-time execution using Simulation->Run.

How to run this model in External Mode:

  1. Open the Analog Input and Analog Output blocks and select your data acquisition board. If there's no board installed, install it using the Install new board button.

  2. Double-click the orange button to switch to External Mode if needed.

  3. Build the model using Code->C/C++ Code->Build Model.

  4. Connect to the real-time code using Simulation->Connect To Target.

  5. Start the real-time execution using Simulation->Run.

Note: To run this model, you must have a data acquisition board plugged into your computer. This model requires DSP System Toolbox.

Was this topic helpful?