Documentation Center

  • Trial Software
  • Product Updates

Stream Input/Output

This model shows how to transfer data through UDP communication protocol using ASCII encoding. The model sends data within one computer, from one UDP port to another. You can modify the model to communicate between two computers by splitting this model into its send and receive parts and running the models on two computers. The yellow blocks are used to send the data, the blue blocks are used to receive the data. Then, please enter the IP addresses of the two computers into the appropriate fields in the Board Setup dialog.

How to run this model in Normal Mode:

  1. Double-click the orange button to switch to Normal Mode if needed.

  2. Start the real-time execution using Simulation->Run.

How to run this model in External Mode:

  1. Double-click the orange button to switch to External Mode if needed.

  2. Build the model using Code->C/C++ Code->Build Model.

  3. Connect to the real-time code using Simulation->Connect To Target.

  4. Start the real-time execution using Simulation->Run.

Was this topic helpful?