Note: This page has been translated by MathWorks. Please click here

To view all translated materials including this page, select Japan from the country navigator on the bottom of this page.

To view all translated materials including this page, select Japan from the country navigator on the bottom of this page.

Third-order intercept point

`oip3 = toi(x)`

`oip3 = toi(x,fs)`

`oip3 = toi(pxx,f,'psd')`

`oip3 = toi(sxx,f,rbw,'power')`

```
[oip3,fundpow,fundfreq,imodpow,imodfreq]
= toi(___)
```

`toi(___)`

`[`

also returns the power, `oip3`

,`fundpow`

,`fundfreq`

,`imodpow`

,`imodfreq`

]
= toi(___)`fundpow`

,
and frequencies, `fundfreq`

, of the two fundamental
sinusoids. It also returns the power, `imodpow`

,
and frequencies, `imodfreq`

, of the lower and upper
intermodulation products. This syntax can use any of the input arguments
in the preceding syntaxes.

`toi(___)`

with no output arguments
plots the spectrum of the signal and annotates the lower and upper
fundamentals (*f*_{1}, *f*_{2}) and
intermodulation products (2*f*_{1} – *f*_{2},
2*f*_{2} – *f*_{1}).
Higher harmonics and intermodulation products are not labeled. The
TOI appears above the plot.

[1] Kundert, Kenneth S. “Accurate and Rapid Measurement
of *IP*_{2} and *IP*_{3}.”
May, 2002. http://www.designers-guide.org/Analysis/intercept-point.pdf.

Was this topic helpful?