Documentation

This is machine translation

Translated by Microsoft
Mouseover text to see original. Click the button below to return to the English verison of the page.

Note: This page has been translated by MathWorks. Please click here
To view all translated materals including this page, select Japan from the country navigator on the bottom of this page.

Attenuator

Model attenuator for RF circuit

  • Library:
  • RF Blockset / Circuit Envelope / Elements

Description

The Attenuator block to attenuates the signal power by a given factor known as Insertion Loss in dB. Commonly, the block matches the impedance of the RF circuit at the input and output ports. You can use attenuators to dampen the power of the incoming signal to protect RF circuits.

Parameters

expand all

Level of insertion loss or attenuation to apply to the signal, specified as a scalar in dB.

Input impedance of the attenuator, specified as a scalar in ohms.

Output impedance of the attenuator, specified as a scalar in ohms.

Select this parameter to simulate thermal noise in the attenuator. You must select Simulate noise in the Configuration block.

This parameter inserts a current noise source with the single-sided power density of 4 kT/R A2/Hz, where:

  • T is the value of the Temperature parameter in the Configuration block. Units are in degrees Kelvin.

  • k is the Boltzmann constant.

Select this parameter to ground and hide the negative terminals. To expose the negative terminals, clear this parameter. By exposing these terminals, you can connect them to other parts of your model.

Introduced in R2016b

Was this topic helpful?