Add bias to input
The Bias block adds a bias, or offset, to the input signal according to
Y = U + bias,
where U is the block input and Y is the output.
The Bias block accepts and outputs real or complex values of the following data types:
For more information, see Data Types Supported by Simulink in the Simulink® documentation.
Specify the value of the offset to add to the input signal.
|Action||Reasons for Taking This Action||What Happens for Overflows||Example|
Select this check box.
Your model has possible overflow, and you want explicit saturation protection in the generated code.
Overflows saturate to either the minimum or maximum value that the data type can represent.
The maximum value that the int8 (signed, 8-bit integer) data type can represent is 127. Any block operation result greater than this maximum value causes overflow of the 8-bit integer. With the check box selected, the block output saturates at 127. Similarly, the block output saturates at a minimum output value of -128.
Do not select this check box.
You want to optimize efficiency of your generated code.
You want to avoid overspecifying how a block handles out-of-range signals. For more information, see Checking for Signal Range Errors.
Overflows wrap to the appropriate value that is representable by the data type.
The maximum value that the int8 (signed, 8-bit integer) data type can represent is 127. Any block operation result greater than this maximum value causes overflow of the 8-bit integer. With the check box cleared, the software interprets the overflow-causing value as int8, which can produce an unintended result. For example, a block result of 130 (binary 1000 0010) expressed as int8, is -126.
When you select this check box, saturation applies to every internal operation on the block, not just the output or result. Usually, the code generation process can detect when overflow is not possible. In this case, the code generator does not produce saturation code.