This is machine translation

Translated by Microsoft
Mouseover text to see original. Click the button below to return to the English verison of the page.

Note: This page has been translated by MathWorks. Please click here
To view all translated materals including this page, select Japan from the country navigator on the bottom of this page.

Run a Simulation Step by Step


The debugger provides various commands that let you advance a simulation from the method where it is currently suspended (the next method) by various increments (see Stepping Commands). For example, you can advance the simulation

  • Into or over the next method

  • Out of the current method

  • To the top of the simulation loop.

After each advance, the debugger displays information that enables you to determine the point to which the simulation has advanced and the results of advancing the simulation to that point.

For example, in GUI mode, after each step command, the debugger highlights the current method call stack in the Simulation Loop pane. The call stack comprises the next method and the methods that invoked the next method either directly or indirectly. The debugger highlights the call stack by highlighting the names of the methods that make up the call stack in the Simulation Loop pane.

In command-line mode, you can use the where command to display the method call stack.

Block Data Output

After executing a block method, the debugger prints any or all of the following block data in the debugger Output panel (in GUI mode) or, if in command line mode, the MATLAB® Command Window:

  • Un = v

    where v is the current value of the block's nth input.

  • Yn = v

    where v is the current value of the block's nth output.

  • CSTATE = v

    where v is the value of the block's continuous state vector.

  • DSTATE = v

    where v is the value of the block's discrete state vector.

The debugger also displays the current time, the ID and name of the next method to be executed, and the name of the block to which the method applies in the MATLAB Command Window. The following example illustrates typical debugger outputs after a step command.

Stepping Commands

Command-line mode provides the following commands for advancing a simulation incrementally:

This command...Advances the simulation...
step [in into]

Into the next method, stopping at the first method in the next method or, if the next method does not contain any methods, at the end of the next method

step over

To the method that follows the next method, executing all methods invoked directly or indirectly by the next method

step out

To the end of the current method, executing any remaining methods invoked by the current method

step top

To the first method of the next time step (i.e., the top of the simulation loop)

step blockmth

To the next block method to be executed, executing all intervening model- and system-level methods


Same as step over

Buttons in the debugger toolbar allow you to access these commands in GUI mode.

Clicking a button has the same effect as entering the corresponding command at the debugger command line.

Continuing a Simulation

In GUI mode, the Stop button turns red when the debugger suspends the simulation for any reason. To continue the simulation, click the Start/Continue button. In command-line mode, enter continue to continue the simulation. By default, the debugger runs the simulation to the next breakpoint (see Set Breakpoints) or to the end of the simulation, whichever comes first.

Running a Simulation Nonstop

The run command lets you run a simulation to the end of the simulation, skipping any intervening breakpoints. At the end of the simulation, the debugger returns you to the command line. To continue debugging a model, you must restart the debugger.

    Note   The GUI mode does not provide a graphical version of the run command. To run the simulation to the end, you must first clear all breakpoints and then click the Start/Continue button.

Related Examples

More About

Was this topic helpful?