Batch Linearization

Extract and analyze multiple linearizations for a model; vary parameter values, operating points, I/O sets

Start Here

You can batch linearize a model using either the linearize command or the slLinearizer interface. To help you decide which tool to use, see Choosing Batch Linearization Tools.

Functions

linearize Linear approximation of Simulink model or block
slLinearizer Interface for batch linearization of Simulink models
getIOTransfer Transfer function for specified I/O set using slLinearizer or slTuner interface
getLoopTransfer Open-loop transfer function at specified point using slLinearizer or slTuner interface
getSensitivity Sensitivity function at specified point using slLinearizer or slTuner interface
getCompSensitivity Complementary sensitivity function at specified point using slLinearizer or slTuner interface
addPoint Add signal to list of analysis points for slLinearizer or slTuner interface
addOpening Add signal to list of openings for slLinearizer or slTuner interface
refresh Resynchronize slLinearizer or slTuner interface with current model state
removePoint Remove point from list of analysis points in slLinearizer or slTuner interface
removeAllPoints Remove all points from list of analysis points in slLinearizer or slTuner interface
removeOpening Remove opening from list of permanent loop openings in slLinearizer or slTuner interface
removeAllOpenings Remove all openings from list of permanent openings in slLinearizer or slTuner interface

Was this topic helpful?