Remove all openings from list of permanent openings in slLinearizer interface
Create an slLinearizer interface for the scdcascade model.
sllin = slLinearizer('scdcascade');
Generally, you configure the interface with analysis points, openings, operating points, and parameter values. For this example, add two openings to the interface.
'y2m' and 'y1m' are the names of two feedback signals in the scdcascade model. The addOpening command adds these signals to the list of openings for sllin.
Remove all the openings from sllin.
To verify that all openings have been removed, display the contents of sllin, and examine the information about the interface openings.
slLinearizer linearization interface for "scdcascade": No analysis points. Use addPoint method to add new points. No permanent openings. Use addOpening method to add new permanent openings. Other properties (with dot notation get/set access): Parameters :  OperatingPoints :  (model initial condition will be used.) BlockSubstitutions :  Options : [1x1 linearize.LinearizeOptions]
Permanent openings, used by the slLinearizer interface, identify locations within a model where the software breaks the signal flow for linearization. The software enforces these openings for every linearization. Use permanent openings to isolate a specific model component for the purposes of linearization. Suppose you have a large-scale model capturing aircraft dynamics and you want to perform linear analysis on the airframe only. You can use permanent openings to exclude all other components of the model from your linearizations. Another example is when you have cascaded loops within your model and you want to analyze a specific loop.
Location refers to a specific block output port within a model. For convenience, you can use the name of the signal that originates from this port to refer to an opening.
You can add permanent openings to an slLinearizer interface when you create the interface or by using the addOpening command. To remove a location from the list of permanent openings, use the removePoint command.
To view all the openings of sllin, type sllin at the command prompt to display the interface contents. For each permanent opening of sllin, the display includes the block name and port number and the name of the signal that originates at this location.