Documentation

Set External Mode Properties for Logging to File

Data is saved to a file by first saving the data to the MATLAB® workspace through a Simulink® Scope block. Before running a real-time application, set signal and triggering properties.

After you create a Simulink model and add a Scope block, you can enter the signal and triggering properties for data logging to a file.

This procedure uses the model sldrtex_model (matlab: open_system(docpath(fullfile(docroot, 'toolbox', 'sldrt', 'examples', 'sldrtex_model')))). It assumes that you have already loaded that model.

  1. In the Simulation window, click Code > External Mode Control Panel.

  2. Click the Signal & Triggering button.

  3. Click the Select all button. From the Source list, select manual. From the Mode list, select normal.

    The X under Signal selection designates that a signal has been tagged for data collection, and T designates that the signal has been tagged as a trigger signal.

  4. In the Duration field, enter the number of sample points in a data buffer. Enter a Duration value equal to the total number of sample points that you must collect for a run. For example, if you have a sample rate of 1000 samples/second and a stop time of 10 seconds, enter:

    10000
    

    Set the time axis for Simulink Scope blocks equal to the sample interval (in seconds) times the number of points in each data buffer. This setting displays one buffer of data across the entire Simulink Scope plot.

  5. Clear the Limit data points to last check box. See Set Scope Parameters for Logging to Workspace.

    For more information, see Set Up an External Mode Communication Channel (Simulink Coder).

  6. Click Close.

    In the External Signal & Triggering dialog box, click the Apply or Close buttons for the changes you made to take effect. You do not have to rebuild your real-time application.

Was this topic helpful?