On the Coverage > Results pane in the Configuration Parameters dialog box, if you select Enable cumulative data collection and Save cumulative results in workspace variable, a coverage running total is updated with new results at the end of each simulation. However, if you change model or block settings between simulations that are incompatible with settings from previous simulations and affect the type or number of coverage points, the cumulative coverage data resets.
When you restore a running total from saved data, the saved results are reflected in the next cumulative report. If a running total exists when you restore a saved value, the existing value is overwritten.
Whenever you report on more than one single simulation, the coverage displayed for truth tables and lookup-table maps is based on the total coverage of all the reported runs. For cumulative reports, this information includes all the simulations where cumulative results are stored. For more information about managing cumulative results, see Access, Manage, and Accumulate Coverage Results.
You can make cumulative coverage results persist between MATLAB® sessions.
1 to restore cumulative results. At the end
of the sessions, use
cvsave to save results to
a file. At the beginning of the next session, use
load the results.
When you save the coverage results to a file using
a model name argument, the file also contains the cumulative running
total. When you load that file into the coverage tool using
you can select whether you want to restore the running total from
You can also calculate cumulative coverage results at the command
line, through the
covdata1 = cvsim(test1); covdata2 = cvsim(test2); cvhtml('cumulative_report', covdata1 + covdata2);