This is machine translation

Translated by Microsoft
Mouseover text to see original. Click the button below to return to the English verison of the page.

Note: This page has been translated by MathWorks. Please click here
To view all translated materals including this page, select Japan from the country navigator on the bottom of this page.

Specify Storage for Requirements Links

Default storage mode for traceability data

By default, the Requirements Management Interface (RMI) stores requirements links in a separate.req file. In the Requirements Settings dialog box, on the Storage tab, you can enable internal storage or reenable external storage. This setting goes into effect immediately and applies to all new models and to existing models with no links to requirements.

If you open a model that already has requirements links, the RMI uses the storage mechanism you used previously with that model, regardless of what your default storage setting is.

To specify the requirements storage setting:

  1. In the model window, select Analysis > Requirements Traceability > Settings.

  2. In the Requirements Settings dialog box, select the Storage tab.

  3. Under Default storage location for requirements links data:

    • To enable internal storage, select Store internally (embedded in model file).

    • To enable external storage, select Store externally (in a separate *.req file).

    These settings go into effect immediately.

Duplicating outgoing links when copying Simulink and Stateflow objects

By default, the Requirements Management Interface (RMI) always duplicates requirements links in copied Simulink® and Stateflow® objects. To only duplicate requirements links when you highlight model requirements before copying objects, select Duplicate links only when model requirements are highlighted.

Was this topic helpful?