This example shows you how to tune the parameter values of and monitor the signals from an algorithm running on LEGO MINDSTORMS EV3 hardware.
When you are developing algorithms, it is often necessary to determine appropriate values of critical algorithm parameters in iterative fashion. Simulink's External mode feature enables you to accelerate the process by letting you change certain parameter values while the model is running on target hardware, without stopping the model. When you change parameter values from within Simulink, the modified parameter values are communicated to the target hardware immediately. The effects of the parameters tuning activity may be monitored by viewing algorithm signals on scopes or displays in Simulink.
This example introduces the Simulink External mode feature by showing you how to:
Configure communications between Simulink and LEGO MINDSTORMS EV3 hardware
Tune parameters of an algorithm from the same Simulink model that is running on the LEGO MINDSTORMS EV3 hardware
Use Simulink scopes to monitor results from an algorithm running on LEGO MINDSTORMS EV3 hardware
We recommend completing Getting Started with LEGO MINDSTORMS EV3 Hardware example.
You will need the following hardware:
LEGO MINDSTORMS EV3 Brick
EV3 Wi-Fi Dongle or USB Ethernet Adaptor (Recommendation: Apple USB Ethernet Adapter)
Please refer to Task 1 and 2 in Getting Started with LEGO MINDSTORMS EV3 Hardware example.
1. Make a note of the IP address of the EV3 brick.
1. Open the Communicating with LEGO MINDSTORMS EV3 Hardware model, which is preconfigured to run on LEGO MINDSTORMS EV3 hardware.
2. In the model, make sure that the Simulation mode on the toolbar is set to External.
3. In the model, click Tools > Run on Target Hardware > Options... . Update the Host to Target Connection parameters with the ones found in Task 1 and click OK.
4. In the model, click the Run button on the toolbar.
This task shows you how to tune the parameter and monitor the execution of hardware from the model.
1. Open the Scope block. The scope displays the value of signal from the left button on the EV3 brick. Press the left button. The scope shows the value of the signal change from 0 to 1.
2. Double-click the Frequency block in the model and change the value of the Constant value parameter to 600. When you click OK or Apply, the tone coming from the speaker of EV3 brick changes
1. Click the Stop button in the Simulink model. This stops both the application on the EV3 brick and the simulation on your host machine.
This example showed a workflow for tuning and monitoring an algorithm running on LEGO MINDSTORMS EV3 hardware. In this example you learned:
How to configure and run a model in External mode on LEGO MINDSTORMS EV3 hardware.
How to tune an algorithm parameter and monitor algorithm execution on LEGO MINDSTORMS EV3 hardware using the External mode feature.