Blackfin537 bf537_uart_tx - Transmit data stream from UART port

Library

Embedded Coder/ Embedded Targets/ Processors/ Analog Devices Blackfin/ ADSP-BF537 EZ-KIT Lite

Description

Configure UART transmission on ADI BF537 based board to send data stream through the UART port of the board. The block requires an input of [Nx1], where N indicates the data length, in an array of uint8 values representing the ASCII characters. Your model can only contain one transmit block per UART port.

If the memory allocation for this block fails, the software generates an error that guides you to increase heap size or reduce data length. To change the heap size, use the System heap size (MAUs) parameter, located in the model Configuration Parameters under Code Generation > IDE Link.

Dialog Box

UART port

Select the UART port the transmit block uses to send data.

Data length

Set the data length, in data words, of each transmission. Match this value to the data size on the In port.

References

ADSP-BF537 EZ-KIT Lite® Evaluation System Manual, Part Number 82-000865-01, available from the Analog Devices Web site.

See Also

Blackfin537 bf537_uart_config, Blackfin537 bf537_uart_rx

© 1984-2012- The MathWorks, Inc.    -   Site Help   -   Patents   -   Trademarks   -   Privacy Policy   -   Preventing Piracy   -   RSS