BittWare Audio-PMC+ - Support for BittWare Audio PMC+ board

Board

BittWare Audio-PMC+

Library

xPC Target Library for BittWare

General Description

The Audio-PMC+ board is an audio board with 8 I/O channels.

The xPC Target block library supports this board with these driver blocks:

• BittWare Audio-PMC+ Analog Input

• BittWare Audio-PMC+ Analog Output

Block parameters for the input and output blocks appear the same.

Board Characteristics

Board name	Audio-PMC+
Manufacturer	BittWare
Bus type	PCI
Access method	Memory mapped
Multiple block instance support	No
Multiple board support	No

Features

• Input and output are in the form of the DSP System Toolbox frame signal type when the frame is larger than a single sample.

• The analog input block outputs a double or 32 bit integer frame of data.

• The Audio-PMC+ board performs acquisition simultaneously for all the selected channels in a model.

• The analog output block is dynamically typed. The integer or double data type is taken from the connection instead of a block parameter.

Hardware Installation Notes

The Audio-PMC+ daughter board might come from BittWare with jumpers installed to boot from an onboard ROM. You must remove these jumpers, as follows:

1. Remove the Audio-PMC+ from the carrier board and look for 6 pairs of pins along one edge. Check if any of the pairs are jumpered.

2. If any pairs are jumpered, remove each jumper and reinstall it with only one pin connected. Leave the other side hanging. Leaving the jumpers like this will leave them available if you want to use the board in ROM bootable mode at some future time.

© 1984-2012- The MathWorks, Inc.    -   Site Help   -   Patents   -   Trademarks   -   Privacy Policy   -   Preventing Piracy   -   RSS