MPL PATI EEPROM Write - MPL PATI EEPROM Write

Library

xPC Target Library for MPL

General Description

The MPL PATI EEPROM Write block writes MPL boot code on the EEPROM. Before executing any xPC Target model that contains an MPL PATI block, you must first write MPL boot code on the EEPROM using the MPL PATI EEPROM Write block.

To flash the EEPROM with the boot code:

1. Add the EEPROM Write block to an empty model. To access the library that contains this block, type

   xpcmpllib

2. Build and execute this model. All the work is completed when the model is downloaded to the target machine.

3. Reboot the target PC.

4. Build and execute the actual model.

Note   Always use this block by itself in an empty model to re-flash the EEPROM. Be sure to run this model only once to write the boot code on the EEPROM. You must reboot the target PC before executing the actual model. Do not include this block in any other model.

Block Parameters

PCI slot

If only one board of this type is in the target PC, enter

-1 

to automatically locate the board.

If two or more boards of this type are in the target PC, enter the bus number and the PCI slot number of the board associated with this driver block. Use the format [BusNumber, SlotNumber]. To determine the bus number and the PCI slot number, type

getxpcpci

© 1984-2012- The MathWorks, Inc.    -   Site Help   -   Patents   -   Trademarks   -   Privacy Policy   -   Preventing Piracy   -   RSS