Functions in Vehicle Network Toolbox

By Category | Alphabetical List

attachDatabase Attach CAN database to messages and remove CAN database from messages
CAN.ChannelInfo Display device channel information
CAN.VendorInfo Display available device vendor information
canChannel Construct CAN channel connected to selected device
canDatabase Create handle to CAN database file
canHWInfo Information on available CAN devices
canMessage Build CAN message based on user-specified structure
canMessageImport Import CAN message log file from third-party tool
canTool Open Vehicle CAN Bus Monitor
configBusSpeed Set bit timing rate of CAN channel
connect Connect XCP channel to slave module
createMeasurementList Create measurement list for XCP channel
discard Discard all messages from CAN channel
disconnect Disconnect from slave module
extractAll Select all instances of message from message array
extractRecent Select most recent message from array of messages
extractTime Select messages occurring within specified time range from array of messages
filterAllowAll Allow all messages of specified identifier type
filterAllowOnly Configure message filter to allow only specified messages
filterBlockAll Configure filter to block messages with specified identifier type
freeMeasurementLists Remove all measurement lists from XCP channel
getEventInfo Get event information about specific event from A2L file
getMeasurementInfo Get information about specific measurement from A2L file
isConnected Return connection status
isMeasurementRunning Indicate if measurement is active
messageInfo Information about CAN messages
pack Pack signal data into CAN message
readDAQListData Read single value of specified measurement
readSingleValue Read single sample of specified measurement from memory
receive Receive messages from CAN bus
replay Retransmit messages from CAN bus
signalInfo Information about signals in CAN message
start Set CAN channel online
startMeasurement Start configured DAQ and STIM lists
stop Set CAN channel offline
stopMeasurement Stop configured DAQ and STIM lists
transmit Send CAN messages to CAN bus
transmitConfiguration Display messages configured for automatic transmission
transmitEvent Configure messages for event-based transmission
transmitPeriodic Configure messages for periodic transmission
unpack Unpack signal data from message
viewMeasurementLists View configured measurement lists on XCP channel
writeSingleValue Write single sample to specified measurement
writeSTIMListData Write to specified measurement
xcpA2L Access A2L file
xcpChannel Create XCP channel
Was this topic helpful?